Measuring quantity alone does not determine the risk

In order to reduce the risks of pesticide use, they must be measured – which is often done by quantity-based indicators. Yet these often fail to identify risks, writes Robert Finger.

Robert Finger

Reducing the risks to humans and the environment from pesticide use is crucial to agricultural and environmental policy worldwide. In Switzerland, two popular initiatives are currently seeking drastic restrictions on the use of pesticides, and in 2017 the Federal Council adopted a national action plan to reduce risks. However, policy measures are only effective if based on measurable and meaningful indicators.

Tractor sprays crop protection agents
The threats that pesticides pose to the environment cannot easily be determined by measurements of quantity. (Image: Countrypixel / stock.adobe.com)

Commonly-used indicators are inadequate

A meaningful indicator makes it possible to classify pesticide applications according to risk. Only then can we identify appropriate measures such as restrictions on application, promotion of certain cultivation practices, or incentive taxes1. But the social and political debate is dominated by quantity-based indicators such as kilograms per hectare.

Such indicators are counterproductive because they overlook risks and may even obscure them. For example, pests are controlled with insecticides, which are applied in low doses but can be highly toxic. Vegetable oils are also used, which are only slightly toxic but sprayed in large quantities.

Both the quantity and the risk of individual substances must be considered in order that we can take effective measures. A study from the USA showed that trends in pesticide use calculated from national statistics may even reverse. This depends on the indicator used; while the amount of herbicides used in the US has increased over time, the risks have decreased2.

Extreme risks remain undetected

In our new study3, we have shown that quantity-based indicators cannot identify particularly high-risk pesticide applications as such. For the study, we tested the two most common quantity indicators (quantity per hectare and standard applications per hectare) and the in Denmark used risk indicator "Pesticide Load". The latter makes it possible to describe, extensively and in detail, the risks to humans and the environment4.

Based on Swiss winter wheat and potato production in the years 2009-2013, we calculated all three indicators in parallel. The analysis is based on observed application patterns of pesticides in various farms over several years, and so presents a realistic picture. We then examined whether the indicators that quantify the amount of pesticide used also allow an assessment of the risks. We calculated this using correlation coefficients and copulas. Correlation coefficients indicate whether there is on average a linear relationship between risk and quantity indicators. Copulas make it possible to investigate this relationship for applications with extremely low and extremely high risks in particular.

?Quantity indicators can lead to distortion and even to a reversal of the intention of the measures introduced.?Robert Finger

The results show that, on average, the larger the quantity of pesticide, the greater the risks. However, extremely high risks are not identified at all by the quantity indicators currently used – and that also holds true for politically controversial pesticides.

Implications for policymaking

Aiming at reducing high quantities or intensities is alone certainly not a meaningful strategy if we want to reduce the risks to human health and the environment. Stipulating for example that "the amount of pesticide applied must be reduced" is not helpful; on the contrary: the use of quantity indicators can lead to distortion and even to a reversal of the intention of the measures introduced by the policy. A sound (inter)national risk indicator is required for a sound crop protection policy. This is what is currently missing in many countries, including Switzerland.

Robert Finger wrote this blog together with Niklas M?hring.

References

1 Zukunftsblog: Protecting plants intelligently
2 Kniss, A. R. (2017). Long-term trends in the intensity and relative toxicity of herbicide use. Nature communications, 8, 14865.
3 M?hring, N., Gaba, S., & Finger, R. (2019). Quantity based indicators fail to identify extreme pesticide risks. Science of The Total Environment 646, 503-523
4 Kudsk, P., J?rgensen, L. N., & ?rum, J. E. (2018). Pesticide Load—A new Danish pesticide risk indicator with multiple applications. Land Use Policy, 70, 384-393.

JavaScript has been disabled in your browser